The Alphacool flow sensor is designed to fit the needs of computer water cooling enthusiasts. As other flow sensors have unusual threads or need an additional electronic device, this Alphacool flow sensor can be used with G1/4 fittings and can be directly connected with a standard 3-pin fan cable to a mother board, a fan controller or an electronic device (Heatmaster, Aquaero, T-Balancer)
Connect to a main board:
The flow sensors will be detected from the main board like a normal 3-pin fan. Normally it is possible to set the main board software this way, that depending on the rotation speed (or if there is no rotation at all) the computer will be shut down. This makes it possible to have a very good and save way to protect the hardware without additional costs.
Connect to a fan controller:
The flow sensor will be detected and will get the input of the rotation speed like a normal 3-pin fan. If the fan controller includes a Display and / or an alarm function, they can be used also with the flow sensor.
Connect to an electronic device:
The signal from the flow sensor will be detected as a “puls” and can be calculated to the needed unit of measurement (for example l/h or g/h). If you use an Alphacool Heatmaster, it is possible to start an alarm when the flow rate is too low or even to shut down the computer.
Measurements: Length: 46mm, outside diameter: 52mm
Cable length: 33cm
Cable plug: 3-pin
Folgende Werte sind ermittelt worden Toleranz +/- 10%:
125rpm entsprechen 190 Liter / Pro stunde
150rpm entsprechen 250 Liter / Pro stunde
175rpm entsprechen 320 Liter / Pro stunde
200rpm entsprechen 390 Liter / Pro stunde
225rpm entsprechen 450 Liter / Pro stunde
250rpm entsprechen 500 Liter / Pro stunde
In praxis the actual pulse per 1000ml may verify, depending on the type of construction and the system you use. Therefore we recommend to make a precise measurement of the flow rate in an installed system whenever exact flow rates are needed (for example for industrial purposes)
Attention: The manufacturer Mayhems advises that Mayhems fluids, especially the Aurora line of products, have been manufactured and distributed solely for show and modding purposes. These should not be utilized in the system for more than 14 days.
We would also like to advise that Mayhems fluids can damage water cooling products, and using Mayhems fluids can thereby void the warranties offered by the following manufacturers: Koolance, Phobya, Alphacool, Aqua Computer, Watercool.
Damages such as: clogging, corrosion of aluminium radiators, deterioration of glued containers, etc., are a consequence of the use of Mayhems, but will not be reimbursed by Mayhems. Use is therefore at one’s own risk.
Clique aqui para exibir esta (s) pergunta (s).
Clique aqui para ver essas avaliações.
Habe nicht ganz so gute Erfahrung machen können mit diesem Artikel. Bei unter 200U/min bleibt das Ding stehen, obwohl ein Durchfluß zu erkennen ist. Deshalb ging der Artikel zurück.